01

Start with the load path, not the decoration

Imagine receiving a beautiful two-level sample: the lid opens cleanly, but as you pull the filled drawer, the upper section shifts or the pull tab becomes hard to reach. The issue may be the interaction of components rather than the pull itself. This is an illustrative purchasing scenario, not a reported MTT project.

List every item, its maximum dimensions, filled weight, fragile features and placement. Establish which surfaces can carry load. Mark what is fixed to the upper compartment, what sits in the drawer and how the intermediate panel is supported. Avoid assuming the slot pattern shown in a visual fits your product.

02

Check the lid and drawer as a complete assembly

Review the lid open and closed, first without contents and then with the proposed upper insert, products, leaflet and tissue. Where a ribbon acts as a lid stay, note its attachment points, resting position and whether it touches the contents. Confirm the opening angle needed for access without treating a rendering as proof of hinge or stay strength.

With the lid closed, slide the empty drawer; repeat with the complete lower set. Look for front-to-front alignment, contact or scraping, unwanted movement and a pull that is easy to grasp. If resistance changes only after loading, investigate the insert, bottom support and local deformation before changing all drawer dimensions. The existing drawer-clearance guide covers sleeve friction and pull placement.

03

Agree how the set is packed and reviewed

Write the sequence: erect the box, fit the upper panel, position each product, load the lower drawer, insert the drawer and close the lid. Record whether products arrive at one packing location and whether the drawer must remain removable. Check finger access without lifting fragile parts by a cap or decoration.

A sample record should identify the drawing revision, actual contents, all included accessories, where friction appears and the change requested. Ask for a revised physical sample when structural changes affect another component. Holmen notes that material and conversion settings affect paperboard behaviour; a board or crease setting cannot be transferred blindly from another job.[1]

04

Ask for a comparable quotation

Request separate lines for box shell, upper support, drawer insert, example and production artwork, sampling, tooling and outer shipping pack. State the quantity for each artwork version and destination. Compare like-for-like components before deciding whether a lower unit price really reflects the same set.

Review the two-tier concept with your product samples. MTT can review structural options and coordinate samples for custom projects from 1,000 pieces per design; the pictured logo, colours and finish are examples.

05

Decision table: record the next action

Buyer decision record
Review pointWhat may go wrongNext decision
Upper compartmentLoaded panel presses the lid or ribbonCheck tallest fitted product and layer stack before moving the panel.
Lower drawerDrawer moves empty but binds when filledReview base support, loaded insert and contact location before changing clearance.
Packing sequenceUpper panel prevents drawer or item loadingTrial the full order with the intended packer and keep the revision.
Release decisionOne component changed after approvalRecheck affected lid, drawer and insert interactions on the revised sample.

Use this as a discussion framework, not as a claim that the pictured concept has been manufactured or passed a test. Keep the actual sample, contents and revision together when comparing changes.

06

Sources

  1. Primary technical reference, accessed 19 November 2026.