01

Measure both mating parts

Record the finished tray outside width, depth and height as well as the sleeve opening after wrapping. Add the loaded insert, card and intended product. Paper wraps, adhesive and an insert that stands proud can affect contact; nominal internal dimensions do not reveal every interface.

02

Locate the first contact

Open the filled drawer slowly and mark where resistance starts: at the sleeve mouth, one tray corner, the insert or the ribbon attachment. Compare the empty tray with the loaded one. If resistance changes only when loaded, investigate the insert and loaded tray rather than immediately reducing the sleeve dimensions.

03

Review pull and customer handling

Check the pull direction and whether the ribbon or tab remains accessible. Ask a person unfamiliar with the box to open it while supporting the sleeve. Observe any exposed bottle or card movement, then repeat removal and replacement. Record the actual sample and avoid extrapolating to a universal clearance or force.

04

Control manufacturing variables

Specify the exact paper, board and finishing stack on the approved sample. A change to wrap, lining, insert or supplier can change the assembled relationship and should prompt a fit review. Iggesund notes that temperature and humidity conditions can influence paperboard handling and properties. Iggesund paperboard handling guidance.

05

Separate fit from distribution

A smooth drawer on the desk shows only the observed handling result. For carrier distribution, identify product, complete outer pack, destination and test requirements with the responsible shipper or laboratory. Include the approved revision and loaded sample in the quotation brief.

06

Compare two sample revisions

Illustrative scenario. A loaded tray slides smoothly when empty but catches near the middle when the insert is fitted. Mark the position without forcing the pull. Remove the insert and inspect its edge and tray wall, then compare the corresponding area in a second sample. Change one suspected interface and repeat with the same filled products. Record both sample revisions, the insertion direction and where resistance begins so the supplier can reproduce the observation.

07

Discuss the packaging brief

See the illustrative packaging concept and send the actual components for a project-specific review. Share dimensions, filled weights, artwork, quantity per design and destination with MTT. We can review a sampling brief for orders from 1,000 pieces per design.