01

Begin with the sealed product

Capsules with similar names can differ in rim diameter, taper and height. Measure the sealed product at its largest points, including the foil flange; identify whether the lid, rim or body may touch the insert. Confirm the number of varieties and how the packer identifies each position. Do not use another brand’s capsule dimensions as your tooling specification.

The coffee capsule selection drawer box shows a twelve-position presentation direction. Use the image to discuss layout; final compatibility depends on the actual capsule and sample.

Coffee capsule selection drawer box with individual positions
Drawer-box presentation reference: confirm actual capsule fit and access on a sample.
02

Choose retention and removal together

A cavity sized only for the capsule body can trap the rim or make the foil difficult to lift without touching it. Decide whether the capsule sits upright, angled or on its side; map a finger-access point before finalising artwork. Compare a paperboard platform with openings, a divider layout and a formed insert against the required presentation and assembly process. Ask the converter to identify the contact surfaces and available material grades rather than assuming any insert is food-contact suitable.

03

A practical sample matrix

CheckUse the actual sample to assessDecision if unsuitable
FitLargest rim and tallest capsule in each positionAdjust cavity or depth
RemovalFinger access without lifting the sealChange opening or orientation
DrawerLoaded tray slides without snaggingReview tray and sleeve clearances
Pack-outActual assortment, outer carton and handlingRevise support and packing sequence

Check the loaded product, not an empty box alone. The drawer clearance guide covers sleeve friction and pull placement; this guide concerns the capsule layout and removal.

04

Keep presentation separate from transit

A retail drawer can provide an ordered reveal, but its insert and sleeve must be reviewed with the complete distribution pack. Ask how many assembled boxes go in each outer carton, whether the insert is fitted by the box supplier or packer, and which handling or transport test applies. ISTA describes testing as an assessment of a packaged-product system; a material or design image is not proof of a passed distribution test.[1]

05

What to include in a quotation

Provide a physical capsule of each format, product weight, seal and contact restrictions, layout sketch, artwork, required quantity and destination. Ask for separate lines for structural development, sample, insert tooling, assembled boxes and outer packing. For a material comparison, the Paperboard Packaging Council describes the difference between paper-wrapped rigid boxes and fold-flat paperboard cartons; actual grade and construction remain project decisions.[2]

06

Sources

  1. ISTA: Can an individual packaging material be certified? Accessed 14 November 2026.
  2. Paperboard Packaging Council: What is paperboard packaging? Accessed 14 November 2026.