01

Mark the surface that cannot rub

A slim spray may pass a simple fit check and still pick up marks when it is rotated out of a snug cavity. Show the printed or labelled zone, seam, cap and any fragile coating on a physical component. Confirm with the product owner which areas are suitable for contact, including the difference between an empty container and the finished labelled unit.

02

Trace the removal path

Observe the customer gripping the body, lifting the part and returning it to the insert. Draw the contact path through the cavity edge, not merely its resting position. A notch that makes the bottle easy to reach can change how it moves in the pack; verify both retention and access with the actual product.

03

Isolate the source of a mark

When a mark appears, record its position and compare it with the cavity edge, lid underside, adjacent bottle and any protective wrap. Change one variable at a time: orientation, contact surface or support geometry. Avoid attributing every rub mark to board grade or proposing a coating without a compatible material review.

04

Illustrative revision

A supplier increases the label height after the original sample. Reinsert the finished labelled part into the approved package and check whether the newly printed area meets a fold or cavity edge. Photograph the exact contact point, identify both revision numbers and agree whether a new sample or additional handling review is required. Product and packaging changes can affect the validity of distribution testing: ISTA retesting guidance.

05

Make the request specific

Send physical labelled components, dimensions with caps, filled weights, photos of unacceptable contact zones, target quantity and destination. Ask MTT to compare viable support and access options, then approve a representative sample. MOQ is 1,000 pieces per design and US$2,000 in product value per order; freight, sample costs and other fees are separate.

06

Compare the support contact

A folded card cradle may touch at discrete folds, while a fitted recess may contact a longer portion of the bottle. More contact is not automatically better or worse: the label finish, pressure and removal path matter. Test comparable complete samples and obtain the product owner’s decision about acceptable marks before signing off. If a sleeve is used, include its thickness and removal sequence in the review.

07

Give the sample a traceable result

Record which bottle, label lot and packaging revision were checked, the number of handling cycles agreed by the parties, lighting and the surfaces inspected. Distinguish a cosmetic mark from a structural failure. If the acceptance limit is undecided, label the result as an observation rather than a pass. This record gives the next supplier something specific to reproduce instead of a generic request for a softer insert.

08

Explore the related packaging

See the illustrative custom packaging concept and the related buyer guide. Artwork, colours and logo are customised for the project; fit and materials require a physical sample.